HP Compaq dc7600 USDT Getting Started Manual page 27

plug it in again. The computer will restart if automatic start
on power loss is set in Computer Setup. If it does not restart,
press the power button to start the computer.
■
Reconfigure your computer after installing a non–plug and
play expansion board or other option. See
Installation Problems" on page 31
■
Be sure that all the needed device drivers have been installed.
For example, if you are using a printer, you need a driver for
that model printer.
■
Remove all bootable media (diskette, CD, or USB device)
from the system before turning it on.
■
If you have installed an operating system other than the
factory-installed operating system, check to be sure that it is
supported on the system.
■
If the system has multiple video sources (embedded or PCI
adapters) installed (embedded video on some models only)
and a single monitor, the monitor must be plugged into the
monitor connector on the source selected as the primary VGA
adapter. During boot, the other monitor connectors are
disabled and if the monitor is connected into these ports, the
monitor will not function. You can select which source will
be the default VGA source in Computer Setup.
Ä
CAUTION: When the computer is plugged into an AC power
source, there is always voltage applied to the system board. You
must disconnect the power cord from the power source before
opening the computer to prevent system board or component
damage.
Getting Started www.hp.com
Getting Started
"Solving Hardware
for instructions.
23