Removing A Multiplexer Expansion Module - IBM BladeCenter HT 8740 Problem Determination And Service Manual

Removing a multiplexer expansion module

To remove a multiplexer expansion module or filler, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Make sure the FRR LED on the multiplexer expansion module is lit. This LED
3. Pull the release handle or handles to the open position. The module moves out
4. Slide the module out of the bay. Within 1 minute, install either another module
5. If you are instructed to return the multiplexer expansion module, follow all
on page 31.
must be lit before removing the module. For more information see "BladeCenter
HT components, controls, and LEDs" on page 14.
of the bay approximately 0.6 cm (0.25 inch).
or a filler into the module bay.
packaging instructions and use any packaging materials for shipping that are
supplied to you.
Chapter 4. Removing and replacing BladeCenter HT components
79