Removing a high-speed I/O module
To remove a high-speed I/O module or module filler, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Remove the bezel as needed to access the high-speed I/O module to be
3. Disconnect all cables from the module.
4. Pull the release handles to the open position. The module moves out of the bay
5. Slide the module out of the bay. Within 1 minute, install either another module
6. If you are instructed to return the high-speed I/O module, follow all packaging
on page 31.
removed (see "Removing a bezel collar" on page 41).
approximately 0.6 cm (0.25 inch).
or a filler into the module bay.
instructions and use any packaging materials for shipping that are supplied to
you.
Chapter 4. Removing and replacing BladeCenter HT components
71