Installing A Bezel - IBM BladeCenter HT 8740 Problem Determination And Service Manual

Installing a bezel

To install the bezel, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Holding the sides of the bezel, orient the bezel so the IBM logo is at the top and
3. Place the bottom edge of the bezel on the bezel retention tab.
4. Rotate the top of the bezel toward the BladeCenter HT unit until the bezel clicks
5. Turn the quarter-turn bezel locks to the locked position.
on page 31.
right corner.
into place.
Chapter 4. Removing and replacing BladeCenter HT components
35