Security Instructions; Installation; How To Use - Create STYLANCE TOP User Manual

When using any electrical appliance, the following basic safety precautions should always
be observed.
• This type of refrigerator is widely used in places such as hotels, offices, student dormitories,
and homes. It adopts high efficiency compressor and classic structural layout. Enjoy the
advantages of low electricity consumption, freezing capacity and ease of use. It contains a
refrigerator compartment and a freezer compartment.
Caution: When defrosting, never use sharp or metal objects to remove frost on the evaporator
surface, as this will damage the evaporator.
• Do not store the bottled drink in the freezer compartment, to prevent it from breaking and
damaging the refrigerator.
• If you are going to use it intermittently, keep it plugged in each time for periods longer than
ten minutes.
• It should be verified that the voltage used is the same as the rated voltage before using the
refrigerator.
• The power plug should have its own separate power outlet to prevent the power cord from
being overheated by other plugs.
• Do not splash water on the refrigerator. Otherwise, it may cause the refrigerator to
malfunction or electric shock.
• Do not store flammable materials such as alcohol, gasoline, LP gas and glue in the
refrigerator.
WARNING: Food should not be stored in the freezer in contact with the wall. When the
surface of the evaporator freezes, it creates a thin layer of ice that would turn anything in
contact with this part of the freezer into a block of ice, which would also hinder the correct
operation of the product.
1. After transportation, make sure the refrigerator is in an upright and level position for
12 hours to allow compressor fluids to redistribute evenly before use. Do not tilt the
refrigerator more than 45° upright when moving it. Do not apply force to any part such as
the condenser, door and its handle to prevent the refrigerator from being deformed, or its
performance will be affected.
2. Make sure there is enough space around the refrigerator for it to work well.
3. The refrigerator should be kept away from high temperatures, heat sources, water sources,
sunlight or humid conditions.
1. The moment you connect the refrigerator correctly to the power supply, the compressor
will automatically turn on and start cooling. Let it cool down, adjust the thermostat to level
3, for at least 4 hours. Then adjust the thermostat dial to the desired setting and place the
food in the refrigerator.
2. The refrigerator temperature can be adjusted by turning the thermostat. Setting the
thermostat dial to 3 - 4 is best for general operation. When the thermostat number is
larger, the cooling capacity is stronger.
3. Don't put too much food in the refrigerator. Open the door less to maintain the temperature
of the refrigerator and save on electricity consumption.
4. When making ice cubes, fill the ice cube tray with drinking water and put it in the freezer.
It takes about 2-3 hours to make ice cubes. Ice cubes can be removed by rotating the ice
tray, but do not twist it up and down; otherwise it might break.
5. Defrost the freezer whenever the layer of frost on the surface reaches 3-4mm. When
defrosting, remove all food, set the thermostat to 0 position, unplug the refrigerator and
open the door. After the frost has melted, discard the water and dry the inside of the
refrigerator. It can then be reset by connecting to power and turning your thermostat to

SECURITY INSTRUCTIONS

INSTALLATION

HOW TO USE

E NGLI SH
7