Updating The Software - Siemens WMH4W640IL Instruction Manual And Installation Instruction

Press the Start button to confirm.
6.
"Ÿš (end) will appear on the display
panel. The network settings have now
been reset. Your appliance is no longer
connected to your home network or the
Home Connect app.
You can exit the Home Connect
7.
settings by pressing the Remote
Start } button.
Notes
If the network settings could not be
■
reset, "§§ (fault) will appear on the
display panel.
If you want to operate the appliance
■
via the Home Connect app again,
you will need to reconnect it to your
home network and to the
Home Connect app either
automatically or manually.

Updating the software

You can update the Home Connect
software on your appliance.Whenever a
new update is available, —˜š (update)
will appear on the display panel.
You can install the update directly via
the message on the display panel or via
the appliance settings.
Switch the appliance on.
1.
Press and hold the Remote start }
2.
button for more than 3 seconds.
'ž£ (connect automatically) will
appear on the display panel.
Turn the programme selector to
3.
position 6. —˜š (update) will appear
on the display panel.
The Start button will flash if a software
update is available.
Press the Start button.
4.
¢"† (yes) will appear on the display
panel.
Press the Start button to confirm.
5.
Update installation will now start. This
process may take several minutes. Do
not switch the appliance off while
updates are being installed.
You can exit the Home Connect
6.
settings by pressing the Remote
start } button.
Home Connect
en
51