Cleaning, Care And Maintenance; Troubleshooting - Buffalo GF439 Instruction Manual

6. At anytime during vacuum cycle pressing the Seal button will override timer and complete the
vacuuming and sealing cycle.
7. After the vacuum process the machine automatically goes to sealing cycle.
8. When sealing, seal time will be shown on the Digital Display and count down from default setting to 0.
(Note: Seal time is adjustable from 0-6 seconds, default setting is 3 seconds. If the
setting time is 0, the machine will not seal.)
9. Take out the bag and check the vacuum and seal. (Note: A good seal will look clear upon inspection.
If the seal is spotty, incomplete, wrinkled, white or milky, remove sealed portion and run vacuum and
seal process again.)
10. Press "ON/OFF" button to stop the machine at any time.
Please store the vacuumed items properly. All perishable foods must be
refrigerated or frozen to prevent spoilage.
Cleaning, Care & Maintenance
Always allow to cool before cleaning.
WARNING: Do not allow any water to spill into the appliance when cleaning.
• Use warm, soapy water and a damp cloth to clean the appliance.
• Dry thoroughly after cleaning.
• A BUFFALO dealer or qualified technician should carry out repairs if required.

Troubleshooting

Fault
The appliance is The unit is not switched on
not working
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Appliance does Bag not correctly positioned
not remove all
Open end of bag is dirty
the air from the
Bag may be punctured
bag
Incorrect bags used
Bags are not Moisture in bag under the sealing
sealing correctly bar
Incorrect bags used
End of bag not placed above sealing
bar
Heat sealing foam bar missing or
incorrectly aligned
GF439_ML_A5_v6_20190829.indb 5
Probable Cause Solution
Check the unit is plugged in correctly and
switched on
Call BUFFALO agent or qualified Technician
Replace the plug fuse
Check power supply
Call BUFFALO agent or qualified technician
Open lid and reposition bag
Clean bag
Replace bag
Call Vacuum Pack machine supplier
Ensure inside of the bag is dry and free from
moisture where it is to be sealed
Call Vacuum Pack machine supplier
Move end of bag over sealing bar
Replace or re-position (Spare part code:AE931)
UK
5
2019/8/29 14:22