HP Brio 8500 Online Manual page 60

5 Insert the drive into the shelf from the front of the computer.
6 Secure the device in position using the screws provided with it. Using screws other than those provided may cause
damage to the device.
7 Connect the power and data cables to the rear of the device. The power connector and data connector are shaped to
fit one way only. Refer to
8 Install any other accessories before replacing the cover and reconnecting the power cords and any telecommunications
cables. Replace the front bezel on the computer.
9 Turn on the display, and then turn on the computer.
10 In Windows, check that the drive has been recognized. To do this, double-click the My Computer icon on the desktop,
the disk drives that are available on your computer are displayed in the My Computer window.
11 Depending on the type of drive you have installed, you may need to install some driver software. This could be done
when you have returned to the operating system.
Troubleshooting
If the new drive is not recognized, you may need to run the Setup program: restart the computer and press
Press <F2> to enter SETUP is displayed at the bottom of the screen. If you have any doubts about using the HP
Setup program, contact your reseller for help.
If the new drive is not recognized, check that you have correctly followed the installation procedure described above.
If there are any errors reported during the computer's startup routine, press
necessary action. If you have any doubts about using the HP Setup program, contact your reseller for help.
If you cannot start your computer properly, remove the drive and try starting your computer again. If the computer
now starts without any problems, there may be a problem with the new drive.
If you experience any other problems as a result of the upgrade, and your computer is supplied with the HP Brio Center,
refer to the support tools for further assistance.
"System Board Connectors" on page 54
3 Upgrading and Adding Accessories
for more information about which connectors to use.
to view the error(s) and take any
when
$