HP Brio 8000 Supplementary Manual page 4

HP Brio PC 80xx/82xx
Task 7 Replacing the Power Supply
Before You Start
• Remove the computer's cover as described in in Task 1
"Replacing the Cover"
Replacing the Power Supply
1. Locate and remove the four screws
the computer.
2. Disconnect all the white connectors
board and drives.
3. Lift the power supply up and away from the com-
puter and replace with new power supply.
4. Replace the four screws and reconnect all connec-
tors .
5. Replace the cover.
6. Ensure the voltage selector switch is set to the correct
value for the country you live in.
Task 8 Replacing Expansion Cards
T-15 & +
Before You Start
• Remove the computer's cover as described in Task 1
"Replacing the Cover".
on the back of
• Remove the system board as described in Task 4
"Replacing the System Board".
Replacing Expansion Cards
1. Locate the expansion card and remove the retaining
screw .
on the system
2. If necessary, remove any cables to the expansion card
(audio cable, for example).
3. Carefully lift out the expansion card, making sure that
it does not make contact with any other part of the
computer.
4. Insert the replacement expansion card into the appro-
priate slot, and refit any cables if necessary.
5. Replace the retaining screw .
6. Replace the system board.
7. Replace the cover.
T-15
Page 4 of 4
Part Number 5967-9546-EN