HP Brio 8000 Supplementary Manual page 3

HP Brio PC 80xx/82xx
6. Locate and remove the screws
7. Replace the system board.
8. Replace the screws .
9. Replace the memory , processor and VRAM
10. Replace the card that holds the expansion cards, then
replace the expansion cards.
11. Slide the system board back into the computer and
replace the screws.
12. Replace all cables into their appropriate sockets.
13. Replace the cover.
Task 5 Replacing the Floppy Disk
Drive
Before You Start
. • Remove the computer's cover as described in Task 1
"Replacing the Cover".
80xx
• Slide the system board chassis out, as described in Task
4 "Replacing the System Board".
Replacing the Floppy Disk Drive
1. Locate the Floppy Disk drive.
2. Remove the cables .
82xx
3. Remove the four screws
4. Slide the Floppy Disk Drive backwards and out of the
computer.
5. Replace the Floppy Disk Drive.
6. Replace the four screws
7. Refit the two cables .
8. Replace the cover.
.
Task 6 Replacing SIMMs/DIMMs
Before You Start
• Remove the computer's cover as described in Task 1
"Replacing the Cover".
• Take out the system board as described in Task 4
"Replacing the System Board".
Replacing SIMMs/DIMMs
T-15
1. Locate the SIMMs/DIMMs on your system board.
2. Press out the two retaining clips .
, two on either side.
3. Holding the SIMM/DIMM by its edges, lift it clear of the
socket.
4. Replace the SIMM/DIMM, pushing it home until the
.
retaining clips
5. Replace the cover.
Page 3 of 4
T-15
80xx
82xx
lock it in place.