Schumacher Electric Farm & Ranch FR01334 Owner's Manual page 11

Automatic battery charger
Table of Contents

Advertisement

Available languages

Available languages

USING THE QUICK-CONNECT CABLE CONNECTORS
Connect any of the three (3) output cable leads to the charger. Make sure to
place the charger on a dry, non-flammable surface.
WARNING: Never connect the clamp and ring terminal connectors together
for use in other applications, such as external battery or other power source
charging, or to extend the output cable length, as reverse polarity and/or
overcharge conditions will occur.
BATTERY CLAMP QUICK-CONNECT
1. Connect the end of the charger output cable to the end of the battery clamp
quick-connect.
2. Follow the steps in previous sections to connect the output clamps to the battery.
3. After a good electrical connection is made to the battery, plug the power cord
into a grounded 120V AC electrical wall outlet.
RING TERMINAL QUICK-CONNECT
The ring connectors permanently attach to the battery, providing easy access
to quickly connect the charger to your battery. This application is appropriate for
motorcycles, lawn tractors, ATVs and snowmobiles.
1. To permanently attach to a battery, loosen and remove each nut from the bolt
at the battery terminal.
2. Connect the red POSITIVE connector ring to the POSITIVE battery terminal.
3. Connect the black NEGATIVE connector ring to the NEGATIVE battery terminal.
4. Replace and tighten the nuts to secure.
5. Connect the cable to the end of the charger output cord.
Take care to keep the wires and plug away from metal and moving parts.
6. Plug the charger power cord into a grounded 120V AC electrical wall outlet.
12V ACCESSORY PLUG QUICK-CONNECT
1. Connect the end of the charger output cable to the end of the 12V accessory
plug quick-connect.
2. Insert the 12V accessory plug into the 12V accessory outlet.
3. Route the power cord from the charger through the vehicle's open window.
4. Plug the charger power cord into a grounded 120V AC electrical wall outlet.
5. If the vehicle's ignition key has to be on in order for the accessory outlet to
supply/receive power, turn the key, without starting the engine.
• 11 •

Advertisement

Table of Contents
loading

Table of Contents