Axis P3935-RL User Manual page 15

AXIS P3935-LR Network Camera
Configure your device
7. In the list of conditions, under Scheduled and recurring, select Scheduled event.
8. In the list of schedules, select After hours .
9. In the list of actions, under Recordings, select Record video while the rule is active.
10. Select where to save the recordings.
11. Select a Camera.
12. Set the prebuffer time to 5 seconds.
13. Set the postbuffer time to 60 seconds.
14. Click Save.
Provide visual indication of an ongoing event
You have the option to connect the AXIS I/O Indication LED to your network camera. This LED can be configured to turn on whenever
certain events occur in the camera. For example, to let people know that video recording is in progress.
Required hardware
• AXIS I/O Indication LED
• An Axis network video camera
Note
AXIS I/O Indication LED should be connected to an output port.
Note
For instructions on how to connect the AXIS I/O Indication LED, see the installation guide provided with the product.
The following example shows how to configure a rule that turns on the AXIS I/O Indication LED to indicate that camera is recording.
1. Go to System > Accessories > I/O ports.
2. Make sure that the port you connected the AXIS I/O Indication LED to is set to Output. Set the normal state to Circuit open.
3. Go to System > Events.
4. Create a new rule.
5. Select the Condition that must be met to trigger the camera to start recording. It can, for example, be a time schedule or
motion detection.
6. In the list of actions, select Record video. Select a storage space. Select a stream profile or create a new. Also set the
Prebuffer and Postbuffer as required.
7. Save the rule.
8. Create a second rule and select the same Condition as in the first rule.
9. In the list of actions, select Toggle I/O while the rule is active, and then select the port the AXIS I/O Indication LED is
connected to. Set the state to Active.
10. Save the rule.
Other scenarios where AXIS I/O Indication LED can be used are for example:
• Configure the LED to turn on when the camera starts, to indicate the presence of the camera. Select System ready as
a condition.
15