Table of Contents
Advertisement
en Basic operation
¡ Observe the information about de-
tergents and care products
→ Page 35.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 19
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.8 Starting the programme
Note: If you want to change the time
until the programme ends, set the
"Ready in" time first.
Press Start/Reload
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a If you start a programme with act-
ive oxygen, the drum lights up
after the programme starts and the
mist that is created can be seen.
a After the programme has ended,
the display shows: -0-.
13.9 Soaking laundry
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press Start/Re-
.
load
To resume the programme, after
3.
the desired soaking time, press
Start/Reload
38
.
.
13.10 Adding laundry
Notes
¡ Observe the information on safety
→ Page 4 and preventing material
damage → Page 11.
¡ If you a start a programme with
active oxygen, you cannot add any
laundry after the programme has
started.
Press Start/Reload
1.
The appliance pauses.
appears, it is not pos-
Note: If
sible to add laundry.
When
goes out, it is possible to
add laundry.
Open the appliance door.
2.
Add or remove laundry.
3.
Close the appliance door.
4.
Press Start/Reload
5.
13.11 Cancelling the pro-
gramme
Notes
¡ Observe the information on safety
→ Page 4 and preventing material
damage → Page 11.
¡ If you cancel a programme with
active oxygen, the door will remain
locked for up to 25 minutes until
there is no longer any active oxy-
gen in the drum.
while the active oxygen is being re-
moved. The door is then unlocked.
Press Start/Reload
1.
Open the appliance door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse
.
.
and
flash
.
programme.
Advertisement
Table of Contents
