Screw the pump cap as far as it
5.
will go.
90°
The handle on the pump cap must
be in a vertical position.
Insert and close the service flap.
6.
2
1
16.6 Cleaning the intake
opening in the rubber
gasket
Regularly check the intake opening
in the rubber gasket for any block-
ages and clean the intake opening.
Open the appliance door.
1.
Cleaning and servicing en
Remove any blockages from the
2.
intake opening.
Note: Do not use any sharp or poin-
ted objects.
16.7 Cleaning the water outlet
hose at the siphon
Switch off the appliance.
1.
Disconnect the appliance's mains
2.
plug from the power supply.
Loosen the hose clamp and care-
3.
fully remove the water outlet hose.
Residual water may leak out.
45