The Wi-Fi Binding Failure From First Time Setup; Offline After Successful Initial Setup - Intex Pure Spa BUBBLE SB-HWF20 Repair Manual

The Wi-Fi binding failure from first time setup

Wi-Fi binding failure is mainly linking to following 2 scenarios.
Scenario #1, Control panel can't pair with the Wi-Fi router or
Scenario #2, Transmission signal failure between control base and the control panel (E81)
1. Control panel can't pair with the Wi-Fi router
Try to pair it in local mode and IOT (the internet of things) mode respectively, touch the power
button of wireless control panel for 5 seconds to begin spa Wi-Fi pairing with your mobile device.
If product pairing failed, we need to observe the indicate status.
• ON/Solid: Product pairing completed successfully.
• Flashing slowly: pairing mode stage. If it's not paired up within 2 minutes, the LED indicator will turn off. Touch
the pairing button for 5 seconds to repeat the pairing process.
• Flashing rapidly: WiFi router/internet network problem
• OFF: WiFi router signal is disconnected with product or first time use–waiting to be paired up with a mobile
device.
Please follow manual to do some troubleshooting, if the problem persists, replace the panel.
2. Transmission signal failure between control base and the control panel (E81)
If the LED display shows E81, please refer to the section "Error code E81"
s
Offline after
In general, it is the problem with networks, please follow the manual to do some troubleshooting. If
LED display still shows the blue dot, blank or indicate fast flashing please replace the control panel.
If the problem persists or shows E81, please refer to
details.
Page 11
Turn on spa and set up app
No
Touch the power button of control panel for 5
seconds
Pairing
Yes
END
successfully
Replace the control panel
Successfully
Yes
Refer to
E81
page#19
2 min
No
Initial Setup
page#19
(page#19)
for section "Error code E81" for more
to fix it.