Continuous Water Drainage; Maintenance - Pro-Elec PELL0307 Manual

Local dehumidifier
Table of Contents

Advertisement

CONTINUOUS WATER DRAINAGE

The dehumidifier features a continuous drainage port. Using a plastic pipe (with an
inner diameter of 10mm) inserted into the drain hole (on intermediate plate), and
arrange the drain pipe through the cut out in the water tank front panel.
The water in the drainage tank can be continuously drained from the continuous
port on the unit into a suitable drain.

MAINTENANCE

Important: In order to avoid an electric shock, power-off the dehumidifier and
disconnect the mains plug before performing any maintenance or repair activities.
Cleaning
Unplug from the mains supply before cleaning.
Do not splash water into the dehumidifier.
Clean the outside of the dehumidifier with a damp, not wet, cloth and dry
thoroughly before using.
Do not use any chemicals, abrasives or solvents, which may damage the surface
of the dehumidifier.
Filters
Clean the filters every two weeks. If the filters become blocked by dust, the efficiency
of the dehumidifier will be reduced.
Remove the air filters on the front of the unit.
Run a vacuum cleaner lightly over the surface of the filters to remove dust.
If the filters are exceptionally dirty wash them in warm water and a mild detergent
and allow to dry thoroughly before refitting.
Note: Do not operate the air dehumidifier without the filters.
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pell0308

Table of Contents