Table of Contents
Advertisement
en Troubleshooting
Problem with results
Errors
Creasing.
Detergent or fabric softener
drips off the seal and col-
lects on the door or in the
seal fold.
The spin result is not satis-
factory. The laundry is too
wet/too damp.
Detergent residue on the
damp washing.
Detergent residue on the dry
laundry.
Leakage
Errors
Water is leaking out at the
water inlet hose.
Water is leaking out at the
water outlet hose.
46
Cause
The spin speed is too high.
The load is too large.
The wrong programme is se-
lected for the type of fabric.
Too much detergent/fabric
softener in the detergent
drawer.
A low spin speed is selected.
The unbalanced load detec-
tion system has interrupted
the spin cycle because the
laundry is unevenly distrib-
uted.
Detergents may contain wa-
ter-insoluble substances that
deposit on the laundry.
Detergents may contain wa-
ter-insoluble substances that
deposit on the laundry.
Cause
Water inlet hose is not cor-
rectly/securely connected.
The water outlet hose is
damaged.
Troubleshooting
The next time you run a wash cycle,
▶
set a lower spin speed.
The next time you run a wash cycle,
▶
reduce the amount of laundry being
loaded.
Select the programmes that are
▶
suitable for the type of fabric.
→ "Programmes", Page 22
When dosing liquid detergent and
▶
fabric softener, observe the mark-
ing in the detergent drawer and do
not dose above this.
The next time you run a wash cycle,
▶
set a higher spin speed.
Redistribute the laundry in the
▶
drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Start the شطفRinse programme.
▶
Brush out the laundry after washing
▶
and drying.
Troubleshooting
Connect the water supply hose cor-
1.
rectly.
→ "Connecting the water inlet
hose", Page 15
Tighten the screw connection.
2.
Replace the damaged water outlet
▶
hose.
Advertisement
Table of Contents
