Clean The Water Inlet Filters - Bosch WAJ20180GC User Manual And Installation Instructions

Table of Contents

Advertisement

en Cleaning and servicing
Residual water may leak out.
Clean the water outlet hose and si-
4.
phon connecting piece.
Reattach the water outlet hose and
5.
secure the connection point using
the hose clamp.
38

Clean the water inlet filters.

Clean the filter in the water inlet in
the event of blockages or if the water
pressure is too low.
Emptying the water inlet hose
Turn off the tap.
1.
Set a programme, except for ‫شطف‬
2.
Rinse, ‫ عصر‬Spin or ‫ تفریغ‬Drain .
Start the programme and leave it
3.
to run for approx. 40 seconds.
Switch off the appliance.
4.
Disconnect the appliance's mains
5.
plug from the power supply.
Cleaning the filter on the tap
Note: Please read the safety informa-
tion → Page 4 to ensure that you use
the appliance safely.
Requirement: The water inlet hose is
empty.
Remove the water inlet hose from
1.
the tap.
Clean the filter with a small brush.
2.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Waj2018sgc

Table of Contents