Table of Contents
Advertisement
en Troubleshooting
Fault
The appliance does
not switch off fully at
the end of a cooking
time.
The time flashes in
the display.
lights up in
the display and no
settings can be made
on the appliance.
A message with ap-
pears in the display,
e.g.
-
.
17.2 Replacing the oven light bulb
If the light in the cooking compartment fails, change
the oven light bulb.
Note: Heat-resistant, 25-watt, 230 V halogen bulbs are
available from the after-sales service or specialist retail-
ers. Only use these bulbs. Hold the new halogen bulbs
only with a clean, dry towel. This increases the service
life of the bulb.
WARNING ‒ Risk of burns!
The appliance and its parts that can be touched be-
come hot during use.
Caution should be exercised here in order to avoid
▶
touching heating elements.
Young children under 8 years of age must be kept
▶
away from the appliance.
WARNING ‒ Risk of electric shock!
When changing the bulb, the bulb socket contacts are
live.
Before replacing the bulb, ensure that the appliance
▶
is switched off in order to prevent a potential electric
shock.
Also unplug the appliance from the mains or switch
▶
off the circuit breaker in the fuse box.
Requirements
¡ The appliance is disconnected from the power sup-
ply.
¡ The cooking compartment has cooled down.
¡ You have a new halogen bulb to replace the old one.
24
Cause and troubleshooting
At the end of a cooking time, the appliance stops heating up. The oven light and cooling fan
do not switch off. For types of heating with air recirculation, the fan continues to run in the
back wall of the cooking compartment.
Turn the function selector to the off position.
▶
a The appliance is switched off.
a The oven light and the fan in the back wall are switched off.
a The cooling fan switches off automatically as soon as the appliance has cooled down.
There has been a power cut.
Reset the time.
▶
→ "Setting the time", Page 16
Childproof lock is activated.
Use
to deactivate childproof lock.
▶
→ "Childproof lock", Page 16
Electronics fault
Press
.
1.
If necessary, reset the time on the clock.
‒
a If the fault was a one-off, the error message disappears.
If the error message appears again, call the after-sales service. State the exact error
2.
message and the E no. for your appliance in full.
→ "Customer Service", Page 25
Place a tea towel in the cooking compartment to
1.
prevent damage.
Turn the glass cover anti-clockwise to remove it.
2.
Pull out the halogen bulb without turning it.
3.
Insert the new halogen bulb and press it firmly into
4.
the socket.
Make sure the pins are positioned correctly.
Depending on the appliance model, the glass cover
5.
may have a sealing ring. Attach the sealing ring.
Screw in the glass cover.
6.
Remove the tea towel from the cooking compart-
7.
ment.
Connect the appliance to the power supply.
8.
Advertisement
Table of Contents
