Table of Contents
Advertisement
Problem
The cycle time is too long or unsatisfacto‐
ry drying result.
The display shows
1) After maximum 6 hours, the programme ends automatically.
2) It can happen that some area remains humid when drying big items (e.g. bed sheets ).
If the drying results are not
satisfactory
• The set programme was incorrect.
• The filter is clogged.
• The Heat Exchanger is clogged.
• There was too much laundry in the
appliance.
• The drum is dirty.
13. TECHNICAL DATA
Height x Width x Depth
Max. depth with the appliance door open
Max. width with the appliance door open
Adjustable height
Drum volume
Maximum load volume
Voltage
1)
.
Possible solution
Load is too small, increase the load or
use the Time Drying programme.
Make sure that the weight of the laundry
is suitable for the duration of the pro‐
gramme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry
in the washing machine again.
Ensure that the room temperature is
higher than +5°C and lower than +35°C.
Optimal room temperature is 18°C to
25°C.
Set the Time Drying or the Extra Dry pro‐
2)
gramme.
If you want to set a new programme, de‐
activate and activate the appliance.
Make sure that the options are suitable
for the programme.
• Incorrect setting of the conductivity
sensor ( See chapter "
Adjustment of the remaining laundry
moisture degree " for better setting).
• The airflow slots are clogged.
• Room temperature is too low or too
high ( optimal room temperature 18°C
to 25°C )
850 x 596 x 630 mm (maximum 659 mm)
1104 mm
958 mm
850 mm (+ 15 mm - feet regulation)
118 l
8 kg
220-230 V
ENGLISH
19
Settings -
Advertisement
Table of Contents
