Advertisement
Quick Links
A
A - Light x 6 B - Stake x 6 C - Transformer x 1 D - 45' wire x 1 E - Photocell x 1
Assembly and Installtion
1
Attaching and installing the light
Push the stake (C) assembly into the
ground.
Do not push on the light.
A
B
C
B
C
2
Connecting the wires
Detach and place the wire connector (D) on opposite sides of the
low voltage cable (not included) from the transformer (not included)
where the xture will be located.
Align and t the main low voltage cable vertically to the slot of the
wire connector (D).
Press the wire connector (D) together untilit is locked around the
main low voltage cable.Pre-set prongs will pierce the cable
insulation and establish contact with the electrical wire inside.
Once the wire connector (D) is in place, wrap it with electrical tape
(not included) for additional protection.
When the lights are installed, turn on the power.
D
D
·
·
·
D
IN
OUT
1
Please contact 1-855-HD-HAMPTON for further assistance.
Use and Care Guide
LED Path Light
E
HAMPTONBAY.COM
1001486801
-LV-PW06
IN
OUT
Advertisement
Related Manuals for HAMPTON BAY NXT-LV-PW06
Summary of Contents for HAMPTON BAY NXT-LV-PW06
- Page 1 1001486801 -LV-PW06 Use and Care Guide LED Path Light A - Light x 6 B - Stake x 6 C - Transformer x 1 D - 45’ wire x 1 E - Photocell x 1 Assembly and Installtion Attaching and installing the light Connecting the wires Push the stake (C) assembly into the ground.
- Page 2 Care & Cleaning Before attempting to clean the xture, disconnect the power to the xture by turning the breaker off or removing the fuse from the fuse box. To clean the xture, use a dry or slightly dampened clean cloth. Do not use chemicals, solvents, or harsh abrasives, as damage to the xture may occur.