Table of Contents
Advertisement
Assembly & Set-Up
Contents of Carton
•
One Lawn Mower
•
One Lawn Mower Operator's Manual
† If Equipped
NOTE: Please be aware that this Operator's Manual covers both
the low and high wheel models of this mower. While this manual
illustrates the low wheel model, the instructions and features
are equally applicable to the high wheel model as well, unless
otherwise noted.
Assembly
NOTE: This unit is shipped without gasoline or oil in the engine.
Fill up with gasoline and oil as instructed in the accompanying
engine manual BEFORE operating your mower.
Handle
1.
Remove any packing material which may be between
upper and lower handles.
a.
Remove wing nuts and carriage bolts from handle as
shown in Fig. 3-1. Do not loosen or remove adjacent
hex head screws.
A
Figure 3-1
b.
While stabilizing mower so it doesn't move, pivot
upper handle up as shown in Fig. 3-2. Do not crimp
cable while lifting the handle up.
2.
Remove the T-bolts from the handle brackets as shown in
Fig. 3-3.
•
One Grass Catcher†
•
One Engine Operator's Manual
3.
Follow the steps below to complete handle assembly:
A
•
One Bottle of Oil
•
One Side Discharge Chute†
a.
Pull upward on the handle until holes in lower
handle (shown in Fig. 3-3 deck cutaway) line up with
holes in handle bracket. See Fig. 3-4.
Figure 3-2
Figure 3-3
3
B
9
Advertisement
Table of Contents
