Bosch KGF49PI40 Instructions For Use Manual page 16

en
4. Open the app and wait until the
refrigerator is displayed.
Use Add to confirm the connection
between the app and the refrigerator.
If the refrigerator is not automatically
displayed, click on Add appliance in
the app and follow the instructions. As
soon as your refrigerator is displayed,
add it with +.
5. Follow the instructions in the app until
the process is complete.
The displays show PA and on.
■
The refrigerator has been
successfully connected to the app.
If the connection has failed, please
■
check whether the mobile device is
connected to the home network
(WLAN).
Then connect the refrigerator to the
app again.
When the display shows Er, reset
■
the Home Connect settings and
perform set-up again from the
beginning.
Verify signal strength
You should verify the signal strength if no
connection can be established.
1. Press the super button and the lock/
alarm off button simultaneously to
open the Home Connect menu.
The display shows Cn.
Note
Press both buttons at exactly the
same time.Button operation is locked
if only the lock/alarm off button is
pressed for a longer period. Press the
lock/alarm off button again until the
lock is deactivated.
2. Press the °C button repeatedly until
the display shows SI. In the second
display, a value appears between
0 (no reception) and 3 (full reception).
16
Note
The signal strength should be at least
2. If the signal strength is too low, the
connection could be interrupted. Place
the router and the refrigerator closer
together, ensure that the connection is
not disturbed by shielding walls or
install a repeater to strengthen the
signal.
Resetting Home Connect settings
If the connection process does not work
or you would like to log the refrigerator
on to a different home network (WLAN),
you can reset the Home Connect
settings:
1. Press the super button and the lock/
alarm off button simultaneously to
open the Home Connect menu.
The display shows Cn.
Note
Press both buttons at exactly the
same time.Button operation is locked
if only the lock/alarm off button is
pressed for a longer period. Press the
lock/alarm off button again until the
lock is deactivated.
2. Press the °C button repeatedly until
the displays rE and oF are shown.
3. Press the + button.
The display shows a short
■
animation and then again oF.
The Home Connect settings have
been reset.
If the display shows Er, start the
■
reset again or call customer
service.