Siemens IQ500 HB578A0S6B User Manual And Installation Instructions page 24

en Shelf supports
Push on the tab marked PUSH behind the rail, and
1.
push the rail to the rear.
Keep the PUSH tab pushed back
2.
rail outwards ⁠ .
Pull the rail out towards the front until the retainer at
3.
the back unhooks.
Remove the pull-out rail.
4.
Clean the pull-out rail.
5.
→ "Cleaning products", Page 20
24
17.4 Attaching the pull-out rail
Note: The pull-out rails only fit on the right or left. Make
sure when you fit them that you can pull them out to-
wards the front.
1.
and swing the
2.
3.
a The retainer
Insert the pull-out rail between the two bars.
Push the retainer in between the lower and the
upper bar.
Keep the PUSH tab pushed in
out rail inwards until the front retainer
between the two bars
Release the PUSH tab.
‒
clicks into place.
and swing the pull-
is located
⁠ .