Checks After Starting Engine; Cooling Water; Warming Up Engine; Electric Start Models - Yamaha FL350A Owner's Manual

TIP:
If the clip is not installed to the engine shut off
switch, the buzzer will sound when the
Start/Stop button is pressed.
EMU36510

Checks after starting engine

EMU41360

Cooling water

Check for a steady flow of water from the
cooling water pilot hole. A continuous flow of
water from the cooling water pilot hole shows
that the water pump is pumping water
through the cooling water passages.
TIP:
When the engine is started, there may be a
slight delay before water flows from the cool-
ing water pilot hole.
ECM02250
NOTICE
If water is not flowing out of the cooling
ZMU07147
water pilot hole at all times while the en-
gine is running, overheating and serious
damage could occur. Stop the engine and
check whether the cooling water inlet on
the lower case or the cooling water pilot
hole is blocked. Consult your Yamaha
dealer if the problem cannot be located
and corrected.
ZMU07148
EMU27670
ZMU07149
EMU41810

Electric start models

After the engine has started, warm up the en-
gine until the engine speed settles at idling
speed. The engine warming-up indicator is
shown on the Multi-Display while the engine
warms up. For further information, see page
38.
Operation

Warming up engine

ZMU05848
64