D-Link DIR-615S/A1 User Manual page 101

DIR-615S Wireless N300 Router
User Manual
Figure 89. The page for creating a new PPTP + Static IP connection. The IP section.
Parameter
IP Address
Netmask
Gateway IP address
Primary DNS server/
Secondary DNS server
Isolate connection
Enable RIP
Enable IGMP Multicast
NAT
Firewall
Ping
For PPTP + Static IP and L2TP + Static IP types
Enter an IP address for this WAN connection.
Enter a subnet mask for this WAN connection.
Enter an IP address of the gateway used by this WAN connection.
Enter addresses of the primary and secondary DNS servers in the
relevant fields.
When the checkbox is selected, the router uses an alternate routing
table for this connection. Select the checkbox only when your ISP
requires this.
Select the checkbox to allow using RIP for this connection.
Select the checkbox to allow multicast traffic from the external
network (e.g. video streaming) to be received.
Select the checkbox if you want one WAN IP address to be used for
all computers of your LAN.
Select the checkbox to enable protection against ARP and DDoS
attacks.
Select the checkbox to allow the router to answer ping requests
from the external network through this connection. For security
reasons, it is recommended not to select this checkbox.
Page 101 of 180
Description
IP
Configuring via Web-based Interface