Hitachi DZMV100EAU Service Manual page 10

Tip: Tip: Tip: Tip: Tip:
The side that will be recorded when SIDE A of disc faces the hand strap is the
opposite side to the "SIDE A" indication.
Cautions: Cautions: Cautions:
Cautions: Cautions:
Most generally available 8 cm DVD- RAM discs can be removed from cartridges
if they are for video cameras; However, before removing disc from cartridge,
read the instruction sheet provided with the disc or consult the disc maker.
Take care with the following when handling the removed disc:
Be sure not to touch disc surfaces.
Be careful not to drop the disc removed from cartridge.
Be sure not to bend the disc.
Do not leave the disc outside the cartridge.
Do not subject the disc to heat.
Do not write on disc with a ball- point pen or pencil.
Be sure not to wipe disc surfaces with thinner,water or anti- static agent.
Use dry, soft cloth to lightly wipe off dust or dirt that adheres to the disc. Never use solvents to clean the disc.
If the disc is removed from cartridge and the data stored by this DVD video camera/recorder is rewritten on devices other
than this DVD video camera/recorder,recording or playback may not be normal,or Disc Navigation may not operate
normally,when the disc replaced in cartridge is used on this DVD video camera/recorder again.
The cartridge protects the surfaces of disc on which high- density recording is possible.Once removed from cartridge, the
disc can be replaced in the cartridge and used with this DVD video camera/recorder, but be sure to observe the
following:
Before replacing the disc in cartridge, make sure that disc surfaces are not scratched,and that no dirt or fingerprint
adheres to them.
Do not record,edit or delete on the disc when scratches, dirt or fingerprints cannot be removed even if disc surface is
cleaned.
When replacing the disc in cartridge, insert it until a click is heard.
Writing similar to recording is be performed even with simple editing or deletion. Make sure that editing or deletion has
been securely performed with the disc removed from cartridge.
Write-protect tabs Write-protect tabs Write-protect tabs Write-protect tabs Write-protect tabs
The DVD-RAM disc cartridge has write-protect tabs to prevent overwriting
on recorded data. Make sure that the write-protect tab is set to the side
where recording is possible.
Cautions: Cautions: Cautions: Cautions: Cautions:
Dust, scratches or dirt on the disc surface may cause block noise
because of the principle of disc recording. This does not indicate a fault.
Be careful when handling the disc so that no dirt or fingerprints adheres
to the disc.
This DVD video camera/recorder has a function that allows recording,
avoiding portions of the disc with dust, scratches or dirt [The DVD video
camera/recorder sets to pause (
recording ( REC )] .
This will interrupt recording for several seconds to several minutes, and
multiple thumbnails will be created in one recording as shown in the
figure. In this case, the recordable time will decrease.
) status and automatically restarts
Laser
Surface to
be recorded
Side B
Recording not possible
Recording possible
Block noise
(Two or more thumbnails may be
created even in one recording.)
A
side A
indication of
disc
Side A
E1 - 5