Brandt CE2605W Instruction Manual page 32

2/INSTALLING YOUR APPLIANCE
TURNTABLE INSTALLATION
Hub (underside)
Glass tray
Turntable shaft
COUNTERTOP INSTALLATION
Remove all packing material and accessories. Examine the oven for any damage such as
dents or broken door. Do not install if oven is damaged.
Cabinet: Remove any protective film found on the microwave oven cabinet surface.
Do not remove the light brown Mica cover that is attached to the oven cavity to protect the
magnetron.
INSTALLATION
1. Select a level surface that provide
open space for the intakeand/or outlet vents (no
built in).
The minimum installation height is 85cm.
A minimum clearance of 3.0 inches (7.5cm) is
required between the oven and any adjacent
walls.
The right side must be open.
The rear surface of appliances shall be placed
against a wall.
(1)Leave a minimum clearance of 12 inches
(30cm) above the oven.
(2)Do not remove the legs from the bottom of the
oven.
(3)Blocking the intake and/or outlet openings can
damage the oven.
30cm
0cm
open
7.5cm
min85cm
Turntable ring assembly
a. Never place the glass tray upside down.
The glass tray should never be res-
tricted.
b. Both glass tray and turntable ring
assembly must always be used during
cooking.
c. All food and containers of food are always
placed on the glass tray for cooking.
d. If glass tray or turntable ring assembly
cracks or breaks, contact your nearest
authorized service center.
2. Electrical connection
• Your installation must be protected by a
enough
16 Amp thermal fuse.
• It is mandatory to use a power point with
a ground
accordance with current safety regulations.
• In your electrical installation, provide a
device that is accessible to the installer,
capable of separating the appliance from
the mains power and whose contact
opening is at least 3 mm at all of the poles.
• If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qua lified persons in order
to avoid a hazard.
WARNING: Do not install oven over a range
cooktop or other heat-producing appliance. I f
installed near or over a heat source, the oven
could be damaged and the warranty would be
void.
The accessible surface may be
hot during operation.
32
terminal, connected
EN
in