Hardware Installation; Software Installation - Sricam SP006 User Manual

1.3 Hardware Installation

Follow the steps below to set up your camera hardware. Make sure to follow each step
carefully to ensure that the camera operates properly
1. Install the Wi-Fi antenna (For wireless IP Camera) .
2. Plug the power adaptor into camera
3. Plug the network cable into camera, the other side to the router/switch
4. It takes about 30 seconds to boot up the camera, When the camera was powered on and
network cable connected, the green led of the real panel will keep on, The yellow led will
keep flash.

1.4 Software Installation

Insert the CD to install the following software:
1. Click "oPlayer.msi"—"Next"—"Install"—"Finish".
Figure 1.2
4