Yamaha FL300A Owner's Manual page 85

TIP:
When the main switch is turned to "
●
(start) with the clip removed from the en-
gine shut-off switch, the buzzer will sound.
Except the single type, if the clip is not in-
●
stalled to the engine shut off switch, the
buzzer will sound when the Start/Stop but-
ton is pressed.
Except the single type, if one of the en-
●
gines has started, it can be stopped by
pressing the Start/Stop button on the All
start/Stop panel.
EMU42170
Procedure for dual station models (main
station)
1. If equipped with the Yamaha Security
System: If the lock mode of the Yamaha
Security System is selected, use the re-
mote control transmitter to select the un-
lock mode. Short beep will sound twice
when unlocking the Yamaha Security
System. For further information, see
page 33.
TIP:
If you lost track of the current security
●
mode, press the lock or unlock button to
reset the security system.
The signal transmission range of the re-
●
mote control transmitter varies depending
on the mounting position of the receiver.
To operate the Yamaha Security System
correctly, use the transmitter as close as
possible from the receiver.
If Yamaha Security System may not oper-
●
ate correctly, repeat the activating proce-
dure once again.
2. Place the control lever in " " (neutral).
ZMU07150
"
TIP:
The start-in-gear protection device prevents
the engine from starting except when in neu-
tral.
3. Turn the main switch "
sure that the digital electronic control-ac-
tive indicator lights. The engine can not
be started when the digital electronic
control-alert indicator lights.
4. The procedure until starting the engine
is the same as that of the single station
models. NOTICE: Never turn the main
switch to "
gine is running. Do not keep the start-
er motor turning for more than 5
Operation
N
ZMU05829
" (on) to make
" (start) while the en-
79