Maruyama S050 Owner's/Operator's Manual page 9

5
Engine will start.
After pulling starting rope gently by two or
three times, pull it hard to start the engine.
[Pulling method for starting rope]
1. Grasp starting rope tight with right hand.
2. Hold chemical tank with left hand.
3. Pull starting rope slowly until resistance is felt.
4. Pull starting rope straight from entrance of
starter.
5. Do not pull starting rope to the end.
6. Don't release starting rope from pulled state,
and let it return to its original state gradually.
C C AUTION
If the engine does not start by repeated action,
try pulling the rope after fully opening the choke.
CAUTION
If the engine still does not start, refer to
page 13.
6
Return choke slowly.
CAUT T ION
Frequent operation of choke when starting
the engine causes too much fuel to be
sucked in,making the engine difficult to start.
In that case, start after making the choke
fully open.
After starting the engine, accelerate bit by bit
quickly by opening and closing the throttle
lever several times.
This operation is to bleed air in the carburetor.
When there is air present, there is the
possibility of poor acceleration and engine
stalling.
Supply fuel prior to use if possible. This will
make starting next time easy
8
Close