Advertisement
User Manual
8
Installation
INSTALLATION POSITIONING
Ensure that your appliance is installed on solid and flat ground, in a level position.
Please do not place the appliance on a slope, soft carpet or wooden floor.
Your appliance should only be installed within an internal environment.
Do not install the appliance outdoors.
REMOVING THE TRANSPORTATION BOLTS
WARNING:
Before using the appliance, the transport bolts must be removed from the
backside of this machine. Please take the following steps to remove the bolts:
Loosen all 4 bolts with a spanner and then remove them.
Use the plugs (supplied) to plug the holes.
Keep the transport bolts for future use.
LEVEL ADJUSTING
If the floor is obviously uneven, your appliance feet need to be
adjusted. If your appliance isn't level, it will cause your appliance to
vibrate, and potentially move from its position.
Once you've positioned your washing machine, press down from
the top in all four corners to ensure that it's completely stable (i.e.
not rocking in any direction). Also use a spirit level to ensure that it
is completely level in all directions.
Should you need to make adjustments, use a spanner to turn the
appliance legs until it makes contact with the floor. Turn the leg
using one hand and then fasten the nut up against the appliance
cabinet, to lock the leg in place.
After making any adjustments to the appliance legs,
re-check to ensure it is level and no rocking occurring.
CONNECT THE INLET PIPE
Connect the hose elbow to the cold water outlet, screwing in a clockwise direction.
Connect the other end of the inlet hose to the water inlet valve on the rear of the
washing machine.
After installation, if there are any leaks detected, remove the hose and re-install using
the steps above. The hose is designed to be used on a standard washing machine cock
outlet.
POSITION THE OUTLET HOSE
The outlet hose (used to drain the discharged water) is to be ideally connected to the
relevant waste pipe, although it can also be positioned to drain into a sink/trough.
Note that the outlet hose has a minimum outlet position of 60cm and a maximum
position of 100cm (as illustrated on the right).
Note: If you are positioning the outlet hose to drain into a sink or trough, please ensure
that it is fixed in place and that the sink remains unblocked at all times.
Advertisement
