Editing; Edit From A Camcorder - JVC HR-S8960E Instructions Manual

40
EN
Edit From A
Camcorder
A
If the camcorder has no S-VIDEO output connector ...
Recorder
AUDIO
VIDEO
input
input
Audio cable (not provided)
Video cable (not provided)
VIDEO OUT
Camcorder
AUDIO OUT
Player EDIT
B
If the camcorder has an S-VIDEO output connector ...
Recorder
AUDIO
input
S-VIDEO
input
Audio cable (not provided)
S-Video cable (not provided)
S-VIDEO OUT
Camcorder
AUDIO OUT
EDIT
Player
You can use a camcorder as the source player and your
recorder as the recording deck.
A
A If the camcorder has no S-VIDEO output connector ...
B If the camcorder has an S-VIDEO output connector ...
● When using a monaural camcorder, connect its AUDIO OUT
● When a Master Edit Control-equipped JVC camcorder is used,
B
To rear panel PAUSE
connector
Press AUX (number key "0") and/or PR to select "F-1" for
the AUDIO and VIDEO input connectors, or "S-1" for the
AUDIO and S-VIDEO input connectors, depending on
the connectors being used.
Mini-plug cable
C
(not provided)
(JVC camcorder
only)
See "PICTURE CONTROL" on page 53.
D
Engage the Play mode of the camcorder.
E
Engage the Record mode of the recorder.
NOTES:
● All necessary cables can be obtained from your dealer.
● When you select "EDIT" to dub tapes in step 3, be sure to
To rear panel PAUSE
connector
Mini-plug cable
(not provided)
(JVC camcorder
only)
Make connections.
... connect the camcorder's AUDIO OUT and VIDEO
OUT connectors to the recorder's front panel AUDIO
and VIDEO input connectors.
... connect the camcorder's AUDIO OUT and
S-VIDEO OUT connectors to the recorder's front panel
AUDIO and S-VIDEO input connectors.
connector to the AUDIO L input connector on your recorder.
the camcorder is capable of controlling the recorder. Refer to
the camcorder's instruction manual for operating procedure.
Set the recorder's input mode.
Set the edit mode.
Start the camcorder.
Start the recorder.
select "AUTO" (or "NORM" when "B.E.S.T." is set to "OFF")
after you finish dubbing the tapes.

EDITING