JVC HR-S8960E Instructions Manual page 23

Next Function Memory
The Next Function Memory "tells" the recorder what to do after
rewinding. Before continuing, make sure the recorder is in the
Stop mode.
a- For Automatic Start Of Playback
3
Press , then press
b- For Automatic Power Off
3
Press , then press
c- For Automatic Timer Standby
3
Press , then press
NOTE:
The Automatic Power Off does not work if "AUTO TIMER" is set
to "ON" ( 53) and if any timer programming has been made.
If "AUTO TIMER" is set to "ON", the recorder directly goes into
the Timer-Standby mode at the same time when the
pressed for the Automatic Power Off.
Repeat Playback
Your recorder can automatically play back the whole tape 100
times repeatedly.
1
Start playback.
4
Press .
2
Activate Repeat Playback.
4
Press and hold for over 5 seconds, then release.
$
● The Play indicator (
) on the front display panel blinks slowly.
● After playing back a tape 100 times, the recorder stops
automatically.
3
Stop Repeat Playback.
8
Press at any time.
4 3 5
● Pressing
, , or
NOTE:
Repeat playback is not possible with a cassette recorded in EP
mode.
4
within 2 seconds.
1
within 2 seconds.
#
(TIMER) within 2 seconds.
1
9
also stops Repeat Playback.
Manual Tracking
Your recorder is equipped with automatic tracking control.
During playback, you can override this and adjust the tracking
manually by pressing the PR buttons.
1
Override automatic tracking.
During playback, press
2
Adjust the tracking manually.
Press PR + or – on the remote control.
p
● Press
again to return to automatic tracking.
is
NOTE:
When a new tape is inserted, the recorder enters the automatic
tracking mode automatically.
Soundtrack Selection
Your recorder is capable of recording three soundtracks (HI-FI L,
HI-FI R and NORM) and will play back the one you select.
During Playback
Pressing AUDIO changes the soundtrack as follows:
TRACK
On-Screen Display
HI FI
j h
L
HI FI
j
L
HI FI
h
NORM
HI FI
NORM
NOTES:
● "HI FI L j h
Hi-Fi stereo tapes are played back in stereo, and the normal
audio track is played back automatically for tapes with only
normal audio.
● For instructions on recording stereo and bilingual
programmes, refer to page 26.
● "O.S.D." must be set to "ON" or the on-screen displays will
not appear (
p
on the remote control.
For Hi-Fi stereo tapes
R
For main audio of Bilingual tapes
For sub audio of Bilingual tapes
R
For audio-dubbed tapes
For audio-dubbed tapes
R" should normally be selected. In this mode,
pg. 53).
23
EN
USE