Setting Up The Audio Options - Toshiba D-VR30SG Owner's Manual

Setting Up the Audio
Options
Allows you to setup the audio device and sound status
settings depending on the audio system in use.
1 With the unit in Stop mode/No Disc mode, press
the MENU button.
Press the ...† buttons to select Setup, then press
2
the OK or √ button.
No Disc
Programme
System
Clock Set
Setup
Install
Language
Audio
Video
Parental Control
MOVE OK
Press the ...† buttons to select Audio, then press
3
the OK or √ button.
Audio setup menu will be displayed.
No Disc
Programme
Digital Output
DTS
Setup
Dynamic Compression
MOVE OK
Press the ...† buttons to select the desired audio
4
option, then press the OK or √ button.
Press the ...† buttons to select the desired item,
5
then press the OK or √ button.
I
Press the RETURN or œ button to return to the
previous menu. Press the MENU button to exit
Note
the menu.
32 - English
Setup
√ √
√ √
√ √
√ √
√ √
√ √
√ √
RETURN EXIT
Audio
: PCM
√ √
: Off
√ √
: On
√ √
RETURN EXIT
❚
Digital Output
• PCM : Converts to PCM(2CH) 48kHz
audio. Select PCM when using the
Analog Audio Outputs.
• Bitstream : Converts to Dolby Digital Bitstream
(5.1CH). Select Bitstream when
using the Digital Audio Output.
Be sure to select the correct Digital Output or
no audio will be heard.
Note
❚
DTS
• Off : Doesn't output digital signal.
• On : Outputs DTS Bitstream via digital output only.
Select DTS when connecting to a DTS
Decoder.
When DTS soundtrack is played, sound is not
output from Analog Audio Output.
Note
❚
Dynamic Compression
This is only active when a Dolby Digital signal is
detected.
• On : When Movie soundtracks are played at low
volume or from smaller speakers, the
system can apply appropriate compression
to make low-level content more intelligible
and prevent dramatic passages from getting
too loud.
• Off : You can enjoy the movie with the standard
Dynamic Range.