Picture/Audio Settings - Toshiba RD-XS24SB Owner's Manual

Function Setup
Customizing the function settings (Continued)
PAL/Auto
HDD
DVD-VIDEO
To select the video system of a disc.
PAL:
To play a PAL disc. Connect a PAL TV to view a
picture.
Auto:
The recorder automatically identifies PAL or NTSC
video system of a disc. Connect a multisystem TV
(PAL/NTSC compatible) to view a picture.
A playback picture may be distorted when detected a
signal change between PAL and NTSC on the disc.
Note:
Alert message is displayed when detected both PAL
and NTSC video system on the same disc.
Custom picture select
HDD
DVD-VIDEO
Select from between 4 picture settings (Normal, Setting
1-3) you stored in the memory.
During the Rate conversion dubbing or dubbing to the
HDD it will be set to Normal.
Custom picture setting
HDD
DVD-VIDEO
You can adjust fine picture quality and store up to 3
custom picture settings in the memory of the recorder.
1) Press the
setting from 3 settings, and then press the
ENTER button.
e.g.
2) Press the
items, and then press the
select each parameter.
Brightness
118
RD-XS24SB_Ope_E_p113-126
Downloaded From Disc-Player.com Toshiba Manuals

Picture/Audio settings

DVD-RW DVD-RW DVD-R DVD-R
DVD-RAM
(VR) (Video) (VR) (Video)
VCD CD
DVD-RW DVD-RW DVD-R DVD-R
DVD-RAM
(VR) (Video) (VR) (Video)
VCD CD
DVD-RW DVD-RW DVD-R DVD-R
DVD-RAM
(VR) (Video) (VR) (Video)
VCD CD
/ button to select a desired
Picture/Audio settings
PAL
PAL/Auto
Normal
Custom picture select
Custom picture setting
Auto
Progressive conversion
Play DNR
Audio out select
Bitstream
Virtual surround Off
NICAM On
/ buttons to select adjustable
/
(0) Darker ⇔ Brighter (14)
118
Contrast
(–7) Lower ⇔ Higher (7)
Color
(–7) Duller ⇔ Brighter (7)
Edge enhance
Soft (ON) ⇔ (OFF) Normal ⇔ Sharp (ON)
Gamma Level
off ⇔ 1 ⇔ 2
To adjust Gamma Level when the picture is too
dark to view.
3) After adjusting the items, press the ENTER
button.
Progressive conversion
HDD DVD-RAM
DVD-VIDEO VCD
To select the system of output signal. (Only when
connected to a PROGRESSIVE TV.)
There are two types of source content in pictures
recorded in DVD video discs: film content (pictures
recorded from films at 24 frames per second) and video
content (video signals recorded at 25 frames in PAL (30
frames in NTSC) per second). Make this selection
according to the type of content being viewed.
Auto:
Select this position normally.
The recorder automatically detects source content,
film or video, of playback source, and converts that
signal in the progressive output format in an
appropriate method.
Video:
The recorder filters video signal, and converts it in the
progressive output format appropriately.
Suitable for playback of video content pictures.
Setting 1
Setting 2
Setting 3 Film:
The recorder converts film content pictures in the
progressive output format appropriately.
Suitable for playback of film content pictures.
The progressive output feature will be most effective
SETUP
under this selection.
buttons to
Note
• Depending on the disc, pictures may be cut off or doubled.
DVD-RW DVD-RW DVD-R DVD-R
(VR) (Video) (VR) (Video)
CD
8/31/05, 11:59 PM