Advertisement
For TV's connected to On Command® system only.
A. Press setup and power button together until solid red light comes on. Next, put in code listed below. Red
light should flash twice and go out. If light does not flash twice and go out, start over.
These codes are for On Command® systems only
For On Command® systems the main code Is 06; if this doesn't work try 02.
For On Command® systems if above code did not work properly start at A again and try Code
05,07,08,10 or new codes for cruise ships 14, 15, 16, 17 .
After putting in code, make sure you are able to operate standard TV functions such as power, channel and
volume
YOU MUST try menu
and make sure you can fully navigate to Pay-Per-View movies.
If code does not work properly start at A again.
Not all buttons will work because this is a universal remote.
For TV's connected to Lodgenet® system only.
YOU MUST READ THIS FIRST
Lodgenet®
: PLEASE HAVE YOUR EXISTING
REMOTE BEFORE CHOOSING
CODE FOR Clean Remote®- Note: Once you find correct code the first time use that same code on the Clean
Remote® In all of your guestrooms.
A. On The Clean Remote press setup and power button together until solid red light comes on. Next, put in
code from list below. Red light should flash twice and go out. If light does not flash twice & go out, start over.
Now carefully look at your existing Lodgenet® guest room remote (not the Clean Remote®) to choose
correct code below
1.If your existing Lodgenet® system remote has part number LRC-3200, LRC-3210 or LRC-3220 on the top of back
enter Code 02 if this doesn't work try 06.
2.If your existing Lodgenet® system remote does not have Rewind, Pause, Play or Fast Forward buttons, use Code 11
#
*
and
3.If your existing Lodgenet® system remote has Rewind, Play and Fast Forward and
symbols, use Code 01
If above codes did not work enter one of these codes. Code 03 or Code 04
After putting in code to Clean Remote®, make sure you are able to operate standard TV functions such as
YOU MUST
try menu and make sure you can fully
power, channel and volume.
navigate to Pay-Per-View movies.
If code does not work properly start at A again.
Not all buttons will work because this is a universal remote.
Note: To return to TV only setup with no Pay-Per-View movie systems press and hold down setup for 3 seconds and then while
still holding down setup, press and hold the CC button down at the same time till red light blinks quickly 3 times, then release both
buttons. Turn over paper and follow instructions on page 1 for TV's not connected to Pay-Per-View Movie systems.
®
®
Lodgenet
and On Command
are registered trademarks of Lodgenet Interactive Corporation
CR2M* Version 3
Clean Remote® is a registered trademark of Noso Control LLC Copyright© 2020, Noso Control, LLC
2
Advertisement
