Table of Contents
Advertisement
bEfOrE & afTEr INSTaLLaTION
before Installation
Please carefully read this manual before installation.
• Solar module installation and maintenance must be
performed by qualified and authorized installer.
• All installation instructions should be read and
understood before performing any installation.
• Do not disassemble the solar module.
• After installation or repair, check that the solar module
are operating properly.
• In the event that the currently used solar module or
parts have been replaced the newly replaced module
and parts must have the same model name and parts
as the previously installed solar module.
• Secure all necessary permits and licenses to install
the solar modules.
• Panels are not intended for use indoors or on moving
vehicles of any kind.
• Industry standard rated specifications are made at
2
conditions of 1000W/m
irradiance and 25°C (77°F)
solar cell temperature. Colder temperatures may
substantially increase voltage and power.
• Keep the solar module and system away from children
at all times.
• Keep the module packed in the carton until the time of
installation.
• Keep flammable gasses away from the installation
site.
• Do not work alone. Please work as part of a team of
two or more people.
• Safety harness use is strongly recommended for
installation.
• Partial shadowing may substantially reduce panel and
system output.
• Care must be taken to avoid low tilt angles which may
cause dirt to buildup on the glass against the frame
edge.
• Dirt build-up on the surface of the panel may
cause active solar cells to be shaded and electrical
performance to be impaired.
All manuals and user guides at all-guides.com
after Installation
• Plug in the connector tightly and ensure that the wiring
• Conduct periodic inspection of the panels for damage
• Check electrical connections for loose connections
• Water, ethanol or a conventional glass cleanser with
• Aggressive and abrasive cleansers or chemicals such
• Deposits of foreign material on the frame surface can
• Perform the wiring work by connecting the connector
properly works.
to front glass, back sheet, frame, junction box, or
external electrical connections.
and corrosion.
a micro-fiber cloth can be used for regular washing or
rinsing of the front glass to remove dust, dirt or other
deposits.
as alkali chemicals including ammonia based solution
should not be used on cleaning the module.
be cleaned by using a wet sponge or cloth and dried
in air or by using a clean chamois.
and wires to the stand away from the roof or ground.
05
Advertisement
Table of Contents
