Page 1
Installation manual PV Solar MODULE Please read this manual carefully before operating your set and retain it for future reference. N-TYPE MODELS LGXXXN1C(W)-E6 LGXXXN1K-E6 LGXXXN1T-E6 www.lg-solar.com...
SAFETY The instructions related to the safety indicated in the Do not approach the damaged following are for preventing unexpected danger or or broken module unless you are damage in advance by safely and exactly using the product. an authorized or qualified expert. Failure to comply may result in DANGER serious bodily injury or death.
Page 4
Do not touch the glass surface or Module frame of the solar module after Module Installing structure installation of the module. It may (Stralght type) Installing structure (bent type) result in injury or death. Heavy objects must be kept off of the solar module.
BEFORE & AFTER INSTALLATION Before Installation Please carefully read this manual before installation. • Partial shadowing may substantially reduce panel and system output and may be the reason for the damage • Solar module installation and maintenance must be of solar module. performed by qualified and authorized installer.
Diodes properties or physical configurations in the same system. • All LG modules are equipped with factory installed • Match the polarities of cables and terminals when bypass diodes. The factory-installed diodes provide making the connections; failure to do so may result in proper circuit protection for the module from damage to the panel.
Shadow Module Mounting • LGE solar module should be installed in a proper site • The LG Electronics’ (LGE) Limited Warranty for solar that there is no shadowing affected by building, chimney, tree, and neighboring module, etc. modules is contingent upon modules being mounted in accordance with the requirements described in this section.
Page 9
• The solar module may be mounted by using the Mounting by using clamps following methods: (*Torque:8~12N∙m) • The module may be fastened to a support by using • When installing modules in heavy snow areas, clamps on both the long edge and the short edge of it is recommended to be taken an appropriate the modules.
Disclaimer of Liability • By beginning to installation process, the installer has to read and completely understand this Installation Manual. • If installer had any questions regarding this installation manual, the installer would have contacted LG with any questions or concerns.
Dimensions of Modules Unit: mm / in. LGXXXN1C(W)-E6 / LGXXXN1K-E6 / LGXXXN1T-E6 60Cell Module Note) Cable length with connector (MC4, 05-8, PV-CO02) Frame Cross section Long Frame Short Frame...
Position Load (mm) Front/Rear(Pa) (mm) Front/Rear(Pa) 0~300 2400/2400 0 ~ 300 5400/2400 800~900 5400/4000 Note) All mechanical installation methods and bolting method in this appendix were not tested by CSA or 3rd party. It is evaluated by LG internal test.
Page 15
Position Load Position Load (mm) Front/Rear(Pa) (mm) Front/Rear(Pa) 0~334 240~440 2400/2155 2155/2155 240~440 0~334 Note) All mechanical installation methods and bolting method in this appendix were not tested by CSA or 3rd party. It is evaluated by LG internal test.
• Use appropriate bolted connections as per clamp manufacturer’s instructions. • Follow the clamp manufacturer’s recommended applied torque to fasten the clamps. Depth <Edge Clamp> a l l o i t n i t It is evaluated by LG internal test.
Unloading Flow Guide If you are unloading using heavy equipment such as a crane, please follow the procedure below. [ Step 1 ] [ Step 2 ] [ Step 3 ] [ Step 4 ] Step 1. Place the packaging on a flat surface. Step 2.
Page 18
Seoul 07336, Korea Contact: solarinfo@lge.com http://www.lg-solar.com This document is subject to change without notice. LG, LG logo and Life's Good are trademarks of LG Electronics, Inc. worldwide. Trademarks and intellectual properties of LG Electronics, Inc. are protected by international copyright laws.