Installation Of Water Inlet Hose; Final Check And Assembling; How To Level The Dishwasher - LG D1452WLF Owner's Manual

INSTALLATION INSTRUCTIONS

Installation of water inlet hose

Connect the water supply hose to the water tap.
(Fig. A)
Some models consist of an inlet valve and hose.
(Fig. B)
After connecting the inlet hose to the tap, turn on
the tap to flush out foreign substances (dirt, sand
or sawdust) in the water lines. Let water drain
into a bucket, and check the water temperature.
Connect the supply hose to the water inlet valve.
Water supply
hose
Fig. A
cold water. If the water can not be maintained
below 65ºC, the dishwasher must be connected
to cold water.
sealing compound to avoid water leaks.
bent.
used and not the existing or old hose.

Final check and assembling

1. Securely hand tighten supply hose to the
water supply.
Plug the power supply cord into an earthed
electrical point and switch on.
2. After installing and prior to using the
dishwasher with crockery, we recommend
that you use the dishwasher on
to rinse through. At this stage it is useful to
ensure that there are no operating problems or
water leaks.
When the dishwasher is used for the first
time, there may be a loud noise, if this
happens, turn off the power and restart the
dishwasher.
Water tap
Fig. B
mode

How to level the dishwasher

After installing the dishwasher, you may notice a
slight sticking of the door to the dishwasher,
when you open or close the door. If this does
happen you need to adjust the level of the
dishwasher.
Case 1. In case the door is slanted to the right
Fig. C
follow these instructions:
1) Unscrew(counter-clockwise) the left leg of
the back side and correct the level.
2) Check the opening of door and repeat if
necessary until the door opens and closes
properly.
should be no slant, stickiness or friction sound.
Case 2. In case the door is slanted to the left
Fig. D
follow these instructions:
1) Check the opening of door if there still
remains sticky or friction sound.
2) Check the opening of door and repeat if
necessary until the door opens and closes
properly.
should be no slant, stickiness or friction sound.
10