General Features; Pin Connections - Sharp 32LW-92H Service Manual

enables the reduction of the stand–by power consumption to approximately 1W while delivering 300mW
in a 150W SMPS.
• Integrated Start–Up Current Source
• Lossless Off–Line Start–Up
• Direct Off–Line Operation
• Fast Start–Up

13.11.2.General Features

• Flexibility
• Duty Cycle Control
• Under voltage Lockout with Hysteresis
• On Chip Oscillator Switching Frequency 40, or 75kHz
• Secondary Control with Few External Components
Protections
• Maximum Duty Cycle Limitation
• Cycle by Cycle Current Limitation
• Demagnetization (Zero Current Detection) Protection
• "Over V Protection" Against Open Loop
CC
• Programmable Low Inertia Over Voltage Protection Against Open Loop
• Internal Thermal Protection
GreenLine TM Controller
• Pulsed Mode Techniques for a Very High Efficiency Low Power Mode
• Lossless Startup
• Low dV/dT for Low EMI Radiations

13.11.3.Pin Connections

13.11.4.Pin Function description
Pin Name
1 Demag
2 ISENSE
3 Control Input
4 Ground
5 Driver
6 VCC
7
8 Vi
AK45 Service Manual
Description
The Demag pin offers 3 different functions: Zero voltage crossing detection (50mV), 24mA current
detection and 120mA current detection. The 24mA level is used to detect the secondary
reconfiguration status and the 120mA level to detect an Over Voltage status called Quick OVP.
The Current Sense pin senses the voltage developed on the series resistor inserted in the source
of the power MOSFET. When I sense reaches 1V, the Driver output (pin 5) is disabled. This is
known as the Over Current Protection function. A 200mA current source is flowing out of the pin 3
during the start–up phase and during the switching phase in case of the Pulsed Mode of
operation. A resistor can be inserted between the sense resistor and the pin 3; thus a
programmable peak current detection can be performed during the SMPS stand–by mode.
A feedback current from the secondary side of the SMPS via the opto–coupler is injected into this
pin. A resistor can be connected between this pin and GND to allow the programming of the Burst
duty cycle during the Stand–by mode.
This pin is the ground of the primary side of the SMPS.
The current and slew rate capability of this pin are suited to drive Power MOSFETs.
This pin is the positive supply of the IC. The driver output gets disabled when the voltage
becomes higher than 15V and the operating range is between 6.6V and 13V. An intermediate
voltage level of 10V creates a disabling condition called Latched Off phase.
This pin is to provide isolation between the Vi pin 8 and the VCC pin 6.
This pin can be directly connected to a 500V voltage source for start–up function of the IC. During
the Start–up phase a 9 mA current source is internally delivered to the VCC pin 6 allowing a rapid
charge of the VCC capacitor. As soon as the IC starts–up, this current source is disabled.
15
17/12/2007