Logging Panel - Safran STIM277H User Manual

DG- Col. #
type
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Table 8: Result file content, standard datagram
7.7

Logging panel

Panel content
Start button
Stop button
Stop criteria slide
Samples box
Average box
Time elapsed
Samples acquired
CRC_errors
Resynch's
Table 9: Logging panel descriptions
Log to file capability:

Quad core processor is recommended when measuring on two gyro modules simultaneously

The size of the log file is only limited by the available space on the storage media in use

The path for result file storage is defined in the active parameter file

The program should be run with administrator rights to ensure the creation and storage of the result file
DOK451 rev.2
Heading Comments
Time in seconds (derived from sample rate). First sample is
Time[s]
always zero.
GYRO_X Gyro signal X-axis
GYRO_Y Gyro signal Y-axis
GYRO_Z Gyro signal Z-axis
GYRO_STS Status-byte for gyro
GYRO_TMP_X Temperature, X-axis gyro
GYRO_TMP_Y Temperature, Y-axis gyro
GYRO_TMP_Z Temperature, Z-axis gyro
GYRO_TMP_STS Gyro temperature status
Counter Sample counter. See product datasheet for details
Latency Sample latency. See product datasheet for details
RxCRC Received CRC
CalCRC Calculated CRC
DG_ID Datagram identifier
Functionality and description
Starts data logging
Stops data logging
User can select between "Manually", "No of samples" and "Time
elapsed" for stopping a measurement series
Used for defining number of samples when logging a finite number of
samples
Used for specifying how many samples should be averaged before
saving the averaged value to file. If values is '1' no averaging is done
Shows the time elapsed since start of test
Shows number of samples acquired
Shows number of CRC errors (normally 0, otherwise the user should
consider to reject results data in any analysis)
Increments from 0 to a number if any re-synchronisations are needed
in order to re-establish data collections from module
Page 23 of 26