Table of Contents
Advertisement
2.1.6 CHECKUP AND ADJUSTMENT OF MECHANISM PHASE
[24]
MODE GEAR
Align the MODE GEAR with the Main Deck
Assembly hole.
Note:
The MODE GEAR may
be displaced during the
mechanism operation,
however it can be
checked fr om the rear
and realigned during
manual assembly.
[29]
MAIN CAM ASSY/[30]SLIDE ARM ASSY
When mounting the SLIDE ARM ASSY align it with the
Main Deck Assembly and MAIN CAM ASSY holes.
Note:
During the mounting pr ocedure, make sure that the[32]
SUB CAM ASSY is in the correct mounting position.
2-14 (No.86700)
[27]
ROTARY ENCODER
Mount the ROT ARY ENCODER by aligning its mark (
and the mark (
) of the Main Deck Assembly.
Note:
Be careful when handling the FPC during mounting.
[32]
SUB CAM ASSY/[33] CONTROL ARM ASSY
Mount the SUB CAM ASSY hole to align with the CONTROL
ARM ASSY and Main Deck Assembly holes and then tighten
them all together with a screw.
Note:
When mounting it, make sure that the[29]MAIN CAM ASSY is
in the correct mounting position.
Fig.2-1-25
)
[34]
REEL GEAR 1
Align the REEL GEAR 1 with
the Main Deck Assembly hole.
Note:
The REEL GEAR 1 may be
displaced during mechanism
operation, however this can
be checked fr om the rear and
realigned during manual
assembly.
Advertisement
Table of Contents
