Table of Contents
Advertisement
Faults
Display panel/
indicator lights do
not function while
the appliance is
running.
The programme
takes longer than
usual.
Detergent residue
on the washing.
In the pause status
Ü (Start/Pause)
flashes very quickly
and a signal sounds.
If a fault cannot be rectified (switching the machine on and off) or a repair is required:
– Switch off the appliance and pull out the mains plug.
– Turn off the tap and call customer service. ~ Page 42
Cause/Remedy
– Power failure?
– Fuse tripped? Switch on/replace fuse.
– If the fault occurs repeatedly, call customer service. ~ Page 42
– Not a fault – unbalanced load detection system adjusts
imbalance by repeatedly distributing the washing.
– Not a fault – foam detection system active – several rinse cycles
are switched on.
– Occasionally phosphate-free detergents contain water-insoluble
residue.
– Select Rinsing or brush the laundry after washing.
– Water level too high. Washing cannot be reloaded. Immediately
close washing machine door.
– Select Ü (Start/Pause) to continue the programme.
41
Advertisement
Table of Contents
