Advertisement
G11 Remote Controller
Temperature Setting
•
To set the desired room temperature,
press the button to increase or
decrease the set temperature.
•
The temperature setting range is
°
°
16
C
30
C
from
to
•
Press both buttons simultaneously to
toggle the temperature setting
°
°
C
F
between
and
Sleep Mode
• Press the button to activate sleep
mode. This function is available
under COOL, HEAT & AUTO
mode.
• When it is activated in COOL
mode, the set temperature will be
°
increased
0.5
C
after 30mins,
°
1
C
after 1 hour and
2
hours.
• When it is activated in HEAT
mode, the set temperature will be
°
decreased
1
C
after 30mins,
°
2
C
after 1 hour and
3
hours.
ON Timer Setting
•
Press the SET button will
activate the off timer function.
•
Set the desired on time by
pressing the SET button
continuously.
•
Press the CLR button to cancel
the off timer setting
Clock Time Setting
•
Press button + or – to increase
or decrease the clock time.
TURBO
SLEEP
°
C
after 2
°
C
after 2
FAN
MODE
ON TIMER
OFF TIMER
SWING
IONIZER
85
On/Off Button
•
Green colour for Cooling Only model
•
Orange colour for Heatpump model
Personalised Setting
•
Press and hold the button for 3s to
initiate personalized setting.
•
Set the individual setting e.g. MODE,
SET TEMP or FAN SPEED and
leave for 4s to save
•
2 groups of settings are allowed to
stored in the handset
Fan Speed Selection
•
Press the button until the desired fan
speed is achieved.
Operating Mode
•
Press the MODE button to select the
type of operating mode.
•
For Cooling only unit, the available
modes are: COOL, DRY & FAN.
•
For Heatpump unit, the available
modes are: AUTO, COOL, DRY,
FAN & HEAT.
OFF Timer Setting
•
Press the SET button will activate the
off timer function.
•
Set the desired off time by pressing
the SET button continuously.
•
Press the CLR button to cancel the
off timer setting
Automatic Air Awing
•
Press the SWING button to activate
the automatic air swing function.
•
To distribute the air to a specific
direction, press the SWING button
and wait until the louver move to the
desired direction and press the
button once again.
Advertisement
