Table of Contents
Advertisement
5200A Verification and Calibration
Introduction
The 5790A can be used as the measuring device to measure a 5200A AC Calibrator. To
do so, replace the procedures in section 4 of the 5200A manual, with the equivalent
procedures contained in this appendix. These new procedures will require additional test
accessories (see Table F-1). Use all other verification and calibration procedures of the
5200A manual as written.
Accessories
Ferrite Toroid Core
3-Foot Coax Cable with BNC Male Connectors
Blocking Capacitor Adapter
Table F-1. Additional Test Accessories
Figure F-1. Blocking Capacitor Adapter
Appendix E
Model
Fluke PN 851188
RG58A/U
Two 33 uf 6V Tantalum Capacitors and a 100- k
Ω metal film resistor mounted on a Pomona
model 1837 plug. (See Figure F-1.)
ff1.bmp
E-1
Advertisement
Table of Contents
