LG LSGS6338 Owner's Manual page 67

Problem
Oven light does not It is time to replace the lamp or the lamp is loose.
work.
• Replace or tighten lamp. See "Changing the Oven Light" section in this Owner's Manual.
The plug on the range is not completely inserted in the electrical outlet.
• Make sure the electrical plug is inserted into a live, properly grounded outlet.
Oven will not Self The oven temperature is too high to set a Self Clean operation.
Clean. (On some
• Allow the range to cool and reset the controls.
models)
Oven controls improperly set.
• See the Self Clean section.
A Self Clean cycle cannot be started if the oven Control Lock / Lockout feature is active.
• See the "Control Lock / Lockout" in "Changing Oven Settings" section.
Oven door does not Oven is too hot.
open after a Self
• Allow the oven to cool below locking temperature.
Clean cycle (On some
models) The control and door may be locked.
• Allow about one hour for the oven to cool after the completion of a Self Clean cycle. The
door can be opened when the lock
The oven is not clean Oven controls not properly set.
after a Self Clean
• See the Self Clean section.
cycle (On some
models) Oven was heavily soiled.
• Clean up heavy spillovers before starting the clean cycle. Heavily soiled ovens may need to
Self Clean again or for a longer period of time.
CLEAN and door The Self Clean cycle has been selected, but the door is not closed.
flash in the display
• Close the oven door.
(On some models)
"Loc" is on in the The oven is locked because of the Control Lock / Lockout feature.
display when you
• Deactivate the Control Lock / Lockout feature.
want to cook (On
some models)
Oven control beeps Electronic control has detected a fault condition.
and displays any F
• Remove the power from the range for five minutes and then reconnect the power. If the
code error.
function error code repeats, call for service.
• Check the main gas shut-off valve or the oven gas shut-off valve and call for service.
The oven racks were The shiny, silver-colored racks were cleaned in a Self Clean cycle.
cleaned in a Self
• Apply a small amount of vegetable oil to a paper towel and wipe the edges of the oven
Clean cycle. (On
racks with the paper towel. Do not use lubricant sprays.
some models)
Displayed colon in This means that the product has just been plugged in, or that it has experienced a
the clock is flashing power interruption.
• This is normal. Reset the clock and any cooking function.
Light can be seen While the Broil function is running, it is normal to see a light between the oven air
through the oven air vents.
vents.
• This is normal.
Possible Cause & Solution
k
is no longer displayed.
TROUBLESHOOTING 67