System board (see
i.
Pen holder (see
j.
Remove the audio/infrared board:
Remove the two Phillips PM2.0×3.0 screws (1) that secure the audio/infrared board to the system
1.
board.
Release the audio/infrared board (2) by sliding it away from you until the connectors on the front
2.
of the board disengage from the openings in the base enclosure.
Remove the audio/infrared board (3).
3.
Reverse this procedure to install the audio/infrared board.
System board on page
Pen holder on page
63)
60)
Component replacement procedures
65