HP Pavilion DV9500 Maintenance And Service Manual page 102

Remove the three Phillips PM2.5×8.0 screws (1) and the three silver Phillips PM2.5×5.0 screws
4.
(2) that secure the system board to the base enclosure.
Remove the power connector cable (1) and the rear USB board cable (2) from the clips built into
5.
the base enclosure.
Use the area immediately behind the optical drive connector board (1) to lift the right side of the
6.
system board (2) until it rests at an angle.
Remove the optical drive connector board (3). The optical drive connector board is available using
7.
spare part number 432985-001.
94 Chapter 4 Removal and replacement procedures