Table of Contents
Advertisement
evenly into the grinding wheel. Move the work slowly
and avoid jamming the work against the wheel. As
the wheel tends to slow down you should
occasionally release the pressure to let the wheel
return to full speed. Grind only on the face of the
grinding wheel and never on the side. (Some wheels
are designed for side grinding and will say so on
their instruction sheets).
Switch
The switch is located on the front of the grinder, on
the base. To turn the tool on depress the side of the
rocker switch on the top side, marked "1". To turn
off the grinder, depress the base side of the rocker
switch, marked "O".
Changing accessories (fig. 4)
Turn off the tool and disconnect from power supply.
Use only wheels that measure in diameter. This
tool has 150mm 12.7mm arbors on both sides.
Follow the steps below to remove and replace an
accessory.
1. Disconnect the plug.
2. Use only grinding wheels with an allowable
speed matching at least the highest no-load
speed of the tool.
3. Use only original black&decker grinding wheels
remove protective cover (f) by loosening (not
removing) the 3 screws (b). Unscrew clamping
nut (e) with a spanne. Remove clamping flange
(d) and grinding wheel for mounting new
grinding wheel handle in reversed order.
4. Perform a sound-test on new grinding wheels
and test-run them without load for at least 5
minutes (stay out of danger area)
MAINTENANCE
Your D
WALT power tool has been designed to
e
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
Optional Accessories
WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. This product must
not be disposed of with normal
household waste.
Should you find one day that your D
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
Separate collection of used products
and packaging allows materials to be
recycled and used again. Re-use of
E NGLISH
WALT, have
e
WALT, recommended
e
WALT product
e
7
Advertisement
Table of Contents
